View Full Version : reading bullet seater problem
08-06-2008, 07:15 PM
I seem to be amking a light "ring" on the oquive of my bullets when seating them!
only see it on 65g vmax mind which is now my bullet of choice!
dies are reading comp so u would think they would be fine!
brass has correct neck tension & is chamferd
08-06-2008, 09:44 PM
Like Ackley says this is nothing to worry about, however there is a fix it which involves forming a radius on the inside edge of the seating stem to give a sort of bell-mouth effect.
09-06-2008, 12:58 PM
ok nice one guys!
it shot in the high .1's @100 so i didnt think it was to bad!
im running the same neck tension as u ackley so should be fine
09-06-2008, 06:24 PM
ur not wrong there!:D
altho the cases are now on there 4x reload and seem to feel harder to push the rounds in then they did the first few times!(batch of 50)
How many reloads u getting out of your brass mate?
10-06-2008, 06:23 PM
sounds like its time to anneal mate
Iwas thinking the same mate
how many laods do u do before annealing?
Powered by vBulletin® Version 4.1.7 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.