HW45 breach seals - bargain.

[40apple40]

i still have some HW45 breach seal O-rings for sale.

i bought a bulk lot as my local gun shop, chichester armoury, tried to charge me £4 for one of them (without p&p).:eek:
even more reasonble retailers charge £2 - £3 each plus another couple of quid p&P. :(

here, i'll give you 6 for just £3, & that includes P&P.

so if you're lucky enough to have an HW45 then why not get these while they're still available.

PM me if you need these & let me know if you prefer paypal (no extra charge) or cheque.

[JamesB]

Thanks, arrived today. should keep me going for a while!:)

[40apple40]

still some left if anyone's interestd.
:)

[christy]

I am. Bit tired, it's late even for me. pm me tomorrow and I'll take 10. Cheers Chris...

[ikarma70]

did you know the old hw45's and the new ones take different sized breech O-rings?

:)

[Snapshot]

Just received my set, thanks. Will have to check they're the right size and my HW45 is not new. If they're not I'll take them in to the shop. :)

Jonathan

[40apple40]

did you know the old hw45's and the new ones take different sized breech O-rings?

:)

thanks for the info. i hadn't heard that before. i just spoke to my local shop & they knew nothing about it either.
my 45 doesn't have the new fibre optic sights or have the white writing on the side & they're the correct ones for that.

any problems with sizing for your 45 though & you'll get a full refund.

thanks,

jc

[ikarma70]

the old hw45 has a smaller thicker seal in comparison to the new 1.
i know this cos i had both a new 1 and an old 1,i mislaid the seal(but found it afterwards:) ) from the old 1 and tried the spare seal that came with my new 45 and it was a different size.

[40apple40]

the old hw45 has a smaller thicker seal in comparison to the new 1.
i know this cos i had both a new 1 and an old 1,i mislaid the seal(but found it afterwards:) ) from the old 1 and tried the spare seal that came with my new 45 and it was a different size.

ok, thanks for that. in that case the seals i have may not fit the new 45s.
however, if in doubt, order anyway because i'll refund in full if you're not 100% satisfied.

thanks.

[Maltoid]

I'll have some please YHPM

Thanks

Eric:)

[40apple40]

bump :)

[targetmark]

recieved today:)fit my 45 which is a 92 model ok.it seems strange that you say the new seals don,t fit the older 45's as the last seal I bought from Chambers earlier this year fitted no problem and is the same size as the ones from 40apple40 unless they were old stock at Chambers ;)

[Adam77K]

Would these fit an HW75? I used to have a 45 and I think the upper frame, barrel etc are identical apart from the latch mechanism.

Adam

[40apple40]

Would these fit an HW75? I used to have a 45 and I think the upper frame, barrel etc are identical apart from the latch mechanism.

Adam

sorry, i dont know. any one else?

[40apple40]

recieved today:)fit my 45 which is a 92 model ok.it seems strange that you say the new seals don,t fit the older 45's as the last seal I bought from Chambers earlier this year fitted no problem and is the same size as the ones from 40apple40 unless they were old stock at Chambers ;)

i think it was the new models that were in question.
i've had no one come back yet to say they've had a problem though.
i bet you paid a few quid for the one from you got from chambers?

[doctordoom]

Hi apple40 I have an HW 45 serial no 367819 no white writing or fancy sights, if your seals would fit this model I would very much like a set. Yours John.
PM sent with e mail details. Thanks:)
In case it makes any differance calibre is .22

[40apple40]

Hi apple40 I have an HW 45 serial no 367819 no white writing or fancy sights, if your seals would fit this model I would very much like a set. Yours John.
PM sent with e mail details. Thanks:)
In case it makes any differance calibre is .22

you have PM.

[JamesB]

my 45 was new this year, white writing and fibre optic sights. The seals fit fine hth:)

[Jega]

Received my seals this morning many thanks bud, Iv'e put a good word in for you on the good deals sticky.:)

[targetmark]

i think it was the new models that were in question.
i've had no one come back yet to say they've had a problem though.
i bet you paid a few quid for the one from you got from chambers?

it was less than what they are charging for them now about £1.50 or there abouts also I was ordering so other bits from them so the postage cost weren't to bad;)but if you ordered just a breech seal and paid the minimum postage they charge then it works out :eek::eek:

[Porky]

pm sent

[christy]

I bought some seals from you and they should arrive soon. I have bought a 45Silver Star that I am collecting next week and it has a spare new seal with it. I will compare and let you know. If it is not right I do not want a refund ( 2 squid bargin) I shall simply pass them on to someone on here who needs them for 16.00, no-no 2 squid same as. Cheers.

[40apple40]

it was less than what they are charging for them now about £1.50 or there abouts also I was ordering so other bits from them so the postage cost weren't to bad;)but if you ordered just a breech seal and paid the minimum postage they charge then it works out :eek::eek:

they're actually £3.24 each from chambers :eek: plus a few quid postage :eek::eek:

thanks for everyone's feedback. :cool:

[40apple40]

they're actually £3.24 each from chambers :eek: plus a few quid postage :eek::eek:

thanks for everyone's feedback. :cool:

oops, my mistake, they are £1.73 + P&P at chambers as you said. looked at the wrong gun :rolleyes:that makes the £4 they charged at chichester armoury seem even worse!

[Snapshot]

Looks like they'll fit my older HW45. I'll take the gun and seals to work on Friday and fit one to make sure. I'll also compare them to the seals in the new HW45s we have in stock.

Jonathan

[40apple40]

i've had just one person who's gun these didn't fit-it looks like some of the very early versions differ.
no problem though as if in the unlikely event they don't fit, you'll get refunded anyway.:)

[Maltoid]

The seals did not fit my version which is a very early model.

Thanks for the refund.

Eric:)

[doctordoom]

Hi Jon, that was quick, :):)
Arrived today, perfect fit in mine. thanks for the deal, you're a gent:D:D
all the best John.

[Porky]

Hi 40apple40,seals arrived today(probably before my payment got to you:)),they're right for my hw45,and also found the spare that came with the gun :o,so I've got plenty now :D........many thanks indeed.

best regards,Keith

[40apple40]

ok, last chance now to buy these.

thanks for all those who've purchased so far.

:)

[smudger]

ok, last chance now to buy these.

thanks for all those who've purchased so far.

:)
sorry buddy message gobaldygook how much are seels

[40apple40]

sorry buddy message gobaldygook how much are seels

:confused:
all details are at the begining of the thread. they're now £3 for 6 inc P&P.:)

jc

[40apple40]

i still have some of these if you need them.:)

£3 for 6.

jc

[tomgriffin]

Hi mate,

Will they fit my HW45? the serial number is: 352131

ATVB,
Tom

[40apple40]

yes they should fit. in the unlikely event there was a problem i'd refund you in full.

they fit both .22 & .177.

[cptman]

hi please see pm
atb cptman

[TCooper]

The HW40 and HW45 use a #009 nitrile o-ring for the breech seal. I think I'm currently using a #009 quad seal which also works fine. If I remember correctly, the first year of production for the HW45 used a metric 5mm ID seal with a 1.5mm cross section. They didn't stick with this size too long.

You can read the 009 o-ring seal size here.
http://www.oringswest.com/

Cheers,
Todd