6.30mm .25 pellets

[james.22]

Dose anyone know any websites were i can order 6.30mm .25 pells???
Got a BSA spitfire which is currently running on H&N 6.35s.
A bit tight!

Apparently bsa (being different as per usual, 13mm rails etc etc) make there .25s 1/2mm smaller than the standard 6.35m:confused:

need to order some preferbly out of work hrs hense WWW needed.

any help would be great

thanks

james

[scgevans]

Mate if it helps -the nice guys at Pellpax sorted me a selection of .25 cal pellets for my Bsa 635 magnum (circa 1989) - the ONLY ones that would actually fit in the barrel without tattooing my thumb were BSA Pylarms and Rhinos (milbro I think -green tin) BSA's grouped better and will be my pellet of choice for that gun -available from Pellpax. Cheers Stu.

[clubshot]

BSA .25's runs well on Prometheus Z24's

www.airgunpellets.com

Just happen to have a good stock ;)

BOB/R

[Rich]

Being picky, 6.35 mm minus 6.30 mm is not 1/2 mm.

Have you tried Superfields in your gun? About 24 grains and very consistent in my Daystate LR90.

Rich

[Len]

0.5 mm off a 6.35 mm you would have to hammer it into the barrel, mind you these baracuda's are amongst the finest of the finest.

Perhaps you should swop the barrel for a Walther-Lothar, they will fit absolutely perfect and will do away with searching for obsolete English barrel-fitting-pellets.

Len

[james.22]

Ok so i never turned up to any of my maths lessons at school:rolleyes:

but thanks for the help guy's much appreciated.

cheers;)