Problem with my NV setup

[Fordy1315]

Bought my first NV system with a IR on Friday, tried it out last night before attaching it to the dayscope and it was excellent - very clear etc.

When I attached it to my day scope I can see the reticle very clear and see through the scope clear apart from the bottom 30% of the picture is a blur, so I can only have the vision of the top 70% through my scope.

I cant work out what is causing this to happen, has anyone had a similar problem or any ideas if I am doing anything wrong.

I have followed all of the instructions so I cant think what is causing this. When I took the NV back off the day scop the picture was all clear again.

Thanks

Paul

[bennyblanco]

i'm guessing if this is an xvd type system that you have left the built in illuminator on and are getting a reflection back into the scope.


ben

[Fordy1315]

That's what I first thought of. I dont use the built in IR as I bought a stronger IR which attaches to the side on the NV. My new IR is positioned to the left side and under the scope so I dont think its that reflecting off the top of the barrel or silencer.

Any other sugestions?

Thanks

[niko]

couple of ideas for you , try realining the illuminater it could ether be partly blocked or not zeroed to your scope or your xvd is not allined with the back of your scope properly

[whiteleggHW77K]

Possible a silly suggestion but....does the monocular have a lense cap with a hole in it for daytime zeroing, and have you taken this off?

Always worth asking the bl€€din obvious:D

Pete:)

[Fordy1315]

Hi Rob

Thanks for the reply.

I am away from home for 2 weeks so I'll have a look next time I'm home and let you know if this is the case.

Thanks again.

Paul