stillair1
29-02-2004, 07:48 PM
Hi
for all you moderator anoracks, here are a few dimensions and pics for the stainless 10.10 PES not revued in this months SS.
Length 283mm, Diameter 32mm, weight 550g.
Pics show one attached to a std length CZ .17hmr varmint 20" barrel.
It comes apart as shown leaving the one piece inner tube on the barrel if required. The rear end bush is fitted with a recessed o ring, which is an additional bit of work to be done by your smithy on fitting.
As the rear bush is integral with the stainless inner tube you are stuffed if you want to fit the mod onto another gun with different barrel diameter. Unless you want to buy another inner that is!
This one is threaded 1/2", so you would have to specify a different thread size at the time of order. I got this one from a batch of 50 that were imported to JMS from Percy Engineering. Only had two left by the time I got there, so be sure to phone if your travelling to pick one up.
Sorry the quality of the pics are a bit soft, there was a bit of tic turd on the lens of the digi cam I borrowed :(
http://photos.fotango.com/p/eba00417069f00000001.jpg
Those with shortened barrels maybe dimensionally challenged unless you want to trim the fore-end as well.
http://photos.fotango.com/p/eba00417069f00000002.jpg
http://photos.fotango.com/p/eba00417069f00000003.jpg
End bush is smeared with grease for easy removal from the barrel.
for all you moderator anoracks, here are a few dimensions and pics for the stainless 10.10 PES not revued in this months SS.
Length 283mm, Diameter 32mm, weight 550g.
Pics show one attached to a std length CZ .17hmr varmint 20" barrel.
It comes apart as shown leaving the one piece inner tube on the barrel if required. The rear end bush is fitted with a recessed o ring, which is an additional bit of work to be done by your smithy on fitting.
As the rear bush is integral with the stainless inner tube you are stuffed if you want to fit the mod onto another gun with different barrel diameter. Unless you want to buy another inner that is!
This one is threaded 1/2", so you would have to specify a different thread size at the time of order. I got this one from a batch of 50 that were imported to JMS from Percy Engineering. Only had two left by the time I got there, so be sure to phone if your travelling to pick one up.
Sorry the quality of the pics are a bit soft, there was a bit of tic turd on the lens of the digi cam I borrowed :(
http://photos.fotango.com/p/eba00417069f00000001.jpg
Those with shortened barrels maybe dimensionally challenged unless you want to trim the fore-end as well.
http://photos.fotango.com/p/eba00417069f00000002.jpg
http://photos.fotango.com/p/eba00417069f00000003.jpg
End bush is smeared with grease for easy removal from the barrel.