Quote Originally Posted by JJSTEALTH
hi all,
this week, if all goes well, i should be finally replacing my small t.d.r cylinder with a larger 410 one,
a couple of questions,is there a better way to empty the cylinder than just firing the rifle until it dies ?
and how easy ect should it all unscrew ?

im just after any pointers that i should be aware of before i "go in",

thanks,

JASON..

I have completely stripped and repaired the aa400, so the aa410 shouldn’t be much different apart from the multi-shot mag.

The only way I can think of is dry firing the gun till empty.
The cylinder should come off very easy, but on new guns they do tend to put a drop of thread lock on the thread to stop movement, so sometimes you may need to heat the back end of the cylinder with a hair dryer to release the thread lock.

The cylinder just unscrews off anti clock wise.
Very easy job to do.



Regards

Replay