First thing to notice is it's size - it's very small for a 6-24, much smaller than the AO model and no bigger than your average 3-12x40. Parallax is set at a minimum of 25 yds and sidewheel marks are close if not spot on with the factory setting (can't be more precise until I've put some range time in). Fters will want to know the minimum it'll focus to and after adjusting and allowing enough overlap at 55 yds to focus in and out again the minimum is 17.5 yds so a fair way from ideal for FT shooting. It'll come a little closer and still focus at 55yds but you loose the out/in/out that you can still get at 17.5yds min. Optics are just what you'd expect from a Bushnell Elite and only really bettered by scopes at a much higher cost.
I purchased this as an allrounder and any FT ability was going to be a bonus. I'll leave it on the factory settings as shooting a 40mm killzone to 25 yds isn't rocket science even if it is a bit blurred. Leaving the factory settings alone should keep the gaps between 50 and 55 a bit bigger and it does appear to be able to split the difference reasonably well (not as as good as the AO model) though not in the same league as my Burris 8-32. At 8x and a 35 yd parallax it gives a similar DOF to my Burris (on 27.5 yds!) for HFT and I've always regarded my Burris as excellent for the HFT job so good news there and should be perfectly ok for SFT too. The extra DOF over the AO model is probably a function of it small size.
For HFT and SFT it should be excellent but for FT you'll either need a close focus adapter or you'll need to simply guess the distances to 17.5 / 25 yds (not a problem in reality unless you are shooting the Anglo).