Quote Originally Posted by Dave Ramshead View Post
The problem on TARGETZERO'S gun was caused by incorrect barrel to breech alignment, which may have been caused while being reassembled after the non standard metal finish had been applied.

To give you an idea of how "out of true" the barrel alignment was, the muzzle end of barrel touched the fill end of the air tube when the figure 8 bracket was removed.

The downwards tension on the barrel was so great, it caused the figure 8 bracket O ring to compress on the lower edge - leaving daylight to be visible on the upper edge.

Mechanical problems aside, it's a disgrace that someone like you should stoop so low as to have a pop at someone for grammer & punctuation - his opinions are as valid as the next unhappy customers.
How has "Non standard metal finish" got any thing to do with any work I may or may not have done to this rifle, I dont do any metal finishing and the barrel would be bent in the condition you describe, certainly not from me.
I mentioned the way it was written because it was terrible!


Ben