scope mounts for a simmons white tail and a cz american .17hmr

[dazzyboi]

Iv just bought a new gun (CZ 452 american) and a new scope (simmons white tail 6.5-20 x 50) and im looking for some good solid scope mounts go go on the gun.

Anyone got any recommendations?

[manxteddy]

I will soon be faced with the same situation.
You will need high mounts probably double screw for security as the WTC is a big scope.
I have one ready for my .17HMR.
If you look around the bbs images and Rimfirecentral .com you will find many images and helpful advice.
Graham
p.s. BKL 257A Mounts are the ones to use.

[dazzyboi]

Any reccomendations would be great as i havnt a clue what im looking for

[manxteddy]

How about filling in your profile ?
Are you sure you have enough experience to be let loose with a firearm as it stikes me you are asking very naive questions.
There is plenty of info about.Try our sponsors website for a start under Scopes and mounts.
Take it to a gunsmith's and try some out
Graham

[foxshooter]

How about posting in the right section

[dazzyboi]

How about filling in your profile ?
Are you sure you have enough experience to be let loose with a firearm as it stikes me you are asking very naive questions.
There is plenty of info about.Try our sponsors website for a start under Scopes and mounts.
Take it to a gunsmith's and try some out
Graham

Umm, yes i am experienced, but every scope mount i have had have been poor quality and causes it to lose zero if its knocked even the slightest.

I have been recommended the hawk mounts so im going to give them ago.

[snoj]

Umm, yes i am experienced, but every scope mount i have had have been poor quality and causes it to lose zero if its knocked even the slightest.

I have been recommended the hawk mounts so im going to give them ago.

I would try sportsmatch, have a look at their website
http://www.sportsmatch-uk.com/
if you look at specifications, it lists the sizes of scope they work with, or you can measure you current set to get an idea of height.

[dazzyboi]

Ok, phoned them, what size are the dovetail's on the cz american 452?

[snoj]

I think they are 3/8"

Have a look at the faq on http://cz452.com/

Thats for the American, not the American Varmint.

[dazzyboi]

I think they are 3/8"

Have a look at the faq on http://cz452.com/

Thats for the American, not the American Varmint.

It doesnt make sence? it refers to the CZ American 452 to have 11mm dovetails, the proceeds to state that some models (Classic) has the 3/8 " dovetails

Done a search on this forum and alot of people were having problems with incorrect alignment with these mounts.

[JLB]

Sportsmatch mounts will fit 11mm & 3/8 dovetail, i changed to sportsmatch from bkl mounts on my varmint as i was getting around 2'' of crossover @ 100yds with the bkl's from a 50yd zero. I'm not familiar with this particular scope but if it has objective end parallax you will need high mounts, dimensions are listed on the sportsmatch website.

cheers john

[dazzyboi]

Found these...


Sportsmatch Reachforward 2 piece High 1"

2 piece, High hight mount to fit 1" scope with up to 56mm lens, For 9.5-11.5mm dove tail Base. Reach forward by 25mm.

[dazzyboi]

Spoke to sportsmatch uk again, assuming that it is 3/8 " (9mm) then id best go for the HT08 Double screw 50mm mounts which have the removable recoil pin..