Career transfer port

[stereotype]

A friend just bought a S/H.22 Career carbine, and for obvious reasons I would like to know the diameter of the aperture in a standard 12 ftpd transfer port, this ones been got at, bet someone knows. DAVID

[Sid]

I think it's 3mm David - most non-FAC ports on PCP's are about that size.

I'd give it a good look over while you are inside. Bodged up transfer ports are often the tip of the iceberg <img src="http://jsramsbottom.co.uk/bbs/e/icon_frown.gif" alt="Frown" width="15" height="15"><!--graemlin:-->

[stereotype]

Thanks Sid, hope your well,I think it would be a LOT less than that it's got about 2mm at present and it's way way over the top. David

[naturalskinhead [TREV]]

David ,standard port is nearer 1.2mm on non fac have a couple in the workshop if you want one

[Sid]

1.2mm - Blimey !!! <img src="http://jsramsbottom.co.uk/bbs/e/icon_eek.gif" alt="Eek" width="15" height="15"><!--graemlin:-->

[stereotype]

Trev, been trying to mail you via your profile, it's being chucked back. David

[naturalskinhead [TREV]]

David ,Y H M

[stereotype]

It hasn't arrived Trev, David

[naturalskinhead [TREV]]

Tried again,

[stereotype]

Trev , nothing here, try it manually, david23newman@aol.com

[naturalskinhead [TREV]]

Fault seems to be my end NTL, David send me an address trevor.murphy@ntlworld.com I'll post one on-Trev

[EGGY]

3mm should be doin bout 25ft lbs

[Davestate]

Oops, double tap.