Just had the Prosport open - A little problem.

[MattLin]

Just had the Prosport open, removing a washer that was causing a little power issue.

Put it back together and give it a test fire - The safety isn't engaging.

Can anyone suggest what I've messed up and the correct way to sort it out?

This was my first time, so go easy please.

Cheers,
Mat

[Raygun]

Are you cocking it fully.

It's the last 1/2" that causes problems

If you do not pull the lever fully down the safety will not operate.

ATB
Ray.

[Murphy]

Try cocking it harder.
You remove the whole block so you dont touch anything to do with the trigger safety.

[MattLin]

Hmmm

Admittedly I only tested with the action out of the stock so far.

I'll put that back on and see if that makes a difference to the cocking.


Edit: Yep - That sorted it.

Cheers.

[u.k.neil]

Remember to tighten the back trigger guard screw (the small one) fully first, then just nip the front (larger) screw.

Neil

[GoodWILLHunting]

I still haven't had my pro sport apart as I've had no need as yet I have noticed that the safety sometimes dose not engage if, as mentioned above, the lever is not fully extended. This also caused me a few sleepless nights until I figured it out.
Willie