Cheers guys, sounds as easy as we thought. We'll do it tomorrow, thanks for the tip Mike it's saved some scratches!
Ryan
Cheers guys, sounds as easy as we thought. We'll do it tomorrow, thanks for the tip Mike it's saved some scratches!
Ryan
The toxicity of lead varies, depending upon the weight of its doseage and its velocity!
Ryan, instead of changing the cylinder and barrel, just change the breech on both guns and then swap the barrels back... Will save the hassle of emptying the cylinders on both guns... Just watch for the O-ring between the action and breech (its quite small and thin...
NO LONGER My s410
The toxicity of lead varies, depending upon the weight of its doseage and its velocity!
Don't forget to empty the air out first!
And the air........ empty it, all of it....first.
"Obviously power will need to be altered when the barrel length changes,"
are you shure ?
the longer barrel for my tdr gave my an extra 1/2 fpe which brought it up to being "low"
the cyl on mine unscrewed easily (once empty) no trouble,
id taken off the end filler and reinserted it so as not to crush the open end,
as always heres a couple of pics ..
both cylinders with gun
and pre chamber
JASON..
lots of takedowns
If removing cylinder, remember to empty it by shooting all air, remove front barrel support and stock, put air tube in vice with rubber sheet in jaws and unscrew from receiver block.
Last edited by AirArmsDavid; 30-10-2007 at 10:47 PM.