webley mk111 trigger wanted

[pennineway.fswo]

I need a later type trigger for a Webley Mk111 and Chambers are out of stock

If anyone has a spare they would like to sell, please pm me

Thanks
John

[pennineway.fswo]

I am not having much luck with sourcing a trigger, so does anyone have an old Mk111 that is beyond repair and that they wish to sell for spares.
Thanks
John

[mechamaniaboy]

Hi, I Have A Webley Hawk Mk111 Rifle In .22 Cal. Is That Any Good To You?

[pennineway.fswo]

Hi, I Have A Webley Hawk Mk111 Rifle In .22 Cal. Is That Any Good To You?

Thanks for the offer but I think they are completely different triggers
I will check the parts diagram (with Mr Chambers) just to be 100%, and if I am wrong then I will get back to you
Thanks again
John

[Troubledshooter]

HI John,

Is it just part number 1000, the trigger blade that you need ?

Will be back online later.

[freewind]

Don`t know if this would be of interest??


http://www.airgunbbs.com/forums/show...t=webley+MK111


Andy Y

[pennineway.fswo]

HI John,

Is it just part number 1000, the trigger blade that you need ?

Will be back online later.

Hi and thanks for reply

Yes it is just the trigger itself that I am after. But Hillers book shows it as part number 83 and Chambers ref. for the part is TR013

I purchased a very nice Mk111 Supertarget last week (with the later Anschutz sights) but after about 30 shots it would then occasionally refuse to latch up (bruised fingers to show for it)

I made the usual adjustment but there was no improvement

When I removed the action from the stock, i noted that the trigger pin (its a simple pin and not the earlier one that screws into the trigger block) was very short and had migrated to one side of the trigger block.

This had allowed the trigger to be supported from one side only and it had badly worn the pin This had caused some misalignment of trigger and sear and the area on the trigger that contacts the sear had worn badly.
I made and fitted a new pin, and dressed the damaged area but the rifle trigger is still unsafe so i will replace it.

The sear shows no signs of wear at all and should be OK
regards
John

[pennineway.fswo]

Don`t know if this would be of interest??


http://www.airgunbbs.com/forums/show...t=webley+MK111


Andy Y

Hi Andy
I may get back to you later
thanks
John

[Troubledshooter]

Yes it is just the trigger itself that I am after. But Hillers book shows it as part number 83 and Chambers ref. for the part is TR013

Part No: AR 83 denotes the trigger for the earlier series 2 & 3 models.
Part No: AR 1000 denotes the trigger for later models.

I have some new AR 1000 triggers should you still want one.

Looking at Chambers list and prices for Mk.3 spares, I think I did the right thing in getting hold of some when the opportunity arose.

[pennineway.fswo]

Part No: AR 83 denotes the trigger for the earlier series 2 & 3 models.
Part No: AR 1000 denotes the trigger for later models.

I have some new AR 1000 triggers should you still want one.

Looking at Chambers list and prices for Mk.3 spares, I think I did the right thing in getting hold of some when the opportunity arose.

Many thanks David
Norton AMC has offered to send me one from a later model which i think should be the correct one. If it does not match the original then i will be in touch
Regards
John