co2 cartridge problem

[ChrisW6]

What Co2 bulbs are you using as they might have ripped your seals in both guns..?

.

[MattR123]

A while back I bought a bag of loose ones from Gerry's of Wimbledon, about 15 in total I think

Can they actually rip a seal?

[ChrisW6]

A while back I bought a bag of loose ones from Gerry's of Wimbledon, about 15 in total I think

Can they actually rip a seal?

Look at the lip of the bottleneck and feel for any sharp edges, they may be just a bad batch..

.

[eredel]

Have you tried a drop of Pellgun oil on the seals or on a cartridge before insertion?
Eric.

[MattR123]

Have you tried a drop of Pellgun oil on the seals or on a cartridge before insertion?
Eric.

Ill try that an report back, thanks

[MattR123]

I put new cartridges in the PPK and twinmaster. The twinmaster now works perfectly, but the ppk did it again, despite me putting some gun oil in. Its most bizarre . I've now run out of cartridges so will have to buy some more to see if it was just those being a dodgey batch.

[Stuart_B]

I put new cartridges in the PPK and twinmaster. The twinmaster now works perfectly, but the ppk did it again, despite me putting some gun oil in. Its most bizarre . I've now run out of cartridges so will have to buy some more to see if it was just those being a dodgey batch.

Do you mean pellgun oil or a generic gun oil.

Pellgun oil is ideal for co2 guns and works wonders for the seals (unless there is damage to them in which case you may have to look at replacing them)

[MattR123]

Do you mean pellgun oil or a generic gun oil.

Pellgun oil is ideal for co2 guns and works wonders for the seals (unless there is damage to them in which case you may have to look at replacing them)

Just normal oil, I'll go and buy some pellgun to see if that works.

thanks