need some help

[astraman1]

right ive just got a pistol a gamo pt80

i just put a co2 capsule in it and tightened it up and it was leaking it out so my question is should there be an o ring or something up inside the gun where the capule connects to seal it any help much appreciated

[harvey_s]

Mines got a co2 cart. in at the mo. - so can't look just yet, but if you look here :
http://www.gunspares.co.uk/shopdispl...cts.asp?page=5
it would appear to show an 'end seal' marked 'PW098' @ £2.81
hope this helps.....

[Phil G]

I suspect the seal (orange bit) is defective. Maybe damaged or too hard. Just fit a new one and away you go. Every time you fit a new CO2 just look inside to make sure it's clean and wipe the top of the CO2 with your finger in case there is contamination.
atb Phil

[cookie]

Just an add on to Phil's advice, put a drop of Pellgun Oil on every other capsule, it will help make a nice air tight seal, and will prevent the pistols seal drying out.

Jason

[astraman1]

Mines got a co2 cart. in at the mo. - so can't look just yet, but if you look here :
http://www.gunspares.co.uk/shopdispl...cts.asp?page=5
it would appear to show an 'end seal' marked 'PW098' @ £2.81
hope this helps.....

your link dont work mate edit i found it now thanx mate will have to order one and see if it solves it

[harvey_s]

this is what yours should look like....

[astraman1]

this is what yours should look like....

cheers mate