Burris Timberline 4.5-14x w/ Ballistic Plex reticle

[simmmo]

I have a couple of the earlier models before assembly moved away from the States Short Mag and Compact Airgun, from what I have read the quality doesn't seem to have suffered but I haven't compared them side by side. I wouldn't shoot HFT or go rabbit shooting in normal light with anything else.

However some people I know have bought and moved on because they find the eye relief very hard to get used to. Another thing to be aware of is that the optics are really good but I find only when your head is exactly in the right spot, use an enhancer. If it isn't the sight picture will appear crap. For HFT I find it helps but for hunting not so good as in HFT you know the plate should look sharp most of the time. For rabbit shooting in lowlight I personally would be better looking over the top of the scope and not through it.

I use mine on 7 mag for HFT and find the way the reticle is perfect for reducers of all sizes and bracketing full size 35, 40, and 45mm KZ. With two aim points and one check point eliminating rangefinding by eye. I only suffer on the longer targets due to a eye brightness problem in my shooting eye due to health related issues/surgery. My 4200s have better glass but I prefer to use the Burris.

If you buy one I have a bracketing chart for how I use mine for HFT and search under Baxterbasics because he has done a cracking review on here of how he uses his to great success.

Andy

[POK!]

This is the ballistic plex on the FFII 2-7x35 Seems slightly different than OP's Timberline. Perhaps even better suited to airgun? or are they the same when mag taken into consideration?

http://s226.photobucket.com/albums/d...rent=001-2.jpg

Viewed @5x @20 yds seems to be approx 3" between centre + and bottom post. Ret is much bolder than appears above.

[simmmo]

On 7 central crosshair and first line down = 1"@35yds.

On both of my ballistic rets.

Andy

[Petervw]

I assume they have 1" tube ?
I am (still) looking for my favourite HFT scope , I have a Hawke Airmax 3-12x44 sr6 now , so far the best I found , tried Viper and Falcon Merlin , both 10x
I use the SR6 (which works great) at 8x , I prefer clear view all the way
at what magnification does the Burris give clear view all the way ?

thanks
Peter

[g.l.w]

After mytherin poor old "Raygun" I decided to dip me toe in the water with the the Timberline 4.5x14x40, hunter knobs [ bought of here] 1st impressions are mighty good, Lightweight and nicely compact, FOV and DOF ok [for me anyway] Sturdily built and the ballistic ret just seems to drop on where i like it , I have tried to induce paralax error but as of yet not getting any, it simply is or isnt if you know what i mean. I have not used it it yet in anger but up to know YES looks good........Only for use to 45 yds mind , HFT,er.....

[simmmo]

I assume they have 1" tube ?
I am (still) looking for my favourite HFT scope , I have a Hawke Airmax 3-12x44 sr6 now , so far the best I found , tried Viper and Falcon Merlin , both 10x
I use the SR6 (which works great) at 8x , I prefer clear view all the way
at what magnification does the Burris give clear view all the way ?

thanks
Peter

They are a 1 inch tube.

I have a Short Mag which is basically the quoted model before assembly shifted out of the States but it only goes down to 23yds ish as the AO marked at 25yds can be wound slightly past the mark not 7yds (that was the compact airgun model). On this setting 8yds are fuzzy not too blurred and 45yds is clear but that is on 7 mag.

Andy