Rapid action bedding -accuracy improvement?

[sureshot]

Hi I used green felt stuck to the sides and near the back theres a screw hole they use for a Mk1 block trigger guard screw a bolt in then cut off so it sticks out about 3/4mm this grips into the stock and pevents movement.

[tlando]

here's my solution...

http://www.airgunadvice.net/viewtopic.php?t=9523

http://www.xmrfire.org/FWB300/uberra...157%5B1%5D.JPG

[Ka-Boom!]

here's my solution...

http://www.airgunadvice.net/viewtopic.php?t=9523

http://www.xmrfire.org/FWB300/uberra...157%5B1%5D.JPG

First link now working, thanks for the info.
But Wow!, the second link shows a great image of very thorough bedding. Does it help the accuracy?

[guidodg]

mine also wiggles...completely unacceptable for a rifle of this price!!! As are quite a few other things on it!

[Rapidnick]

If you have this problem first check that the bolt is not too long. I have found that stocks vary in thickness around the bolt fixing. Either that or the countersunk hole on the outside of the stock is sometimes drilled too deep. Anyway, try using one or more extra washers until the action is really tight in the stock. Packing like inner tube rubber is fine as well but I would go the bolt route first.

[Tafty]

How much movement are you looking at, me personally would look at the base of the stock and make sure its nice and flat , one centre bolt should be ample when tightened up,

[Ka-Boom!]

How much movement are you looking at, me personally would look at the base of the stock and make sure its nice and flat , one centre bolt should be ample when tightened up,

The action 'clonks' from side to side when taking off or replacing the buddy bottle. This can be lessened by tightening the action bolt (which is OK length, Cheers Nick!), but still not ideal.
I have cut a business card into 4, and sandwiched 2 strips each side between the stock and action, one fore the other aft. This now holds the action firmly, but I can see no accuracy improvement on an indoor 35 yard range.
Again, I'll have have to wait for a perfectly still day to test at longer range outdoors.

[DEL67]

here's my solution...

http://www.airgunadvice.net/viewtopic.php?t=9523

http://www.xmrfire.org/FWB300/uberra...157%5B1%5D.JPG

Loose action aside, quick fill AND a pressure gauge now that i would be interested in. Have you any pictures of these in the stock and out. Didn't know you could have both.
Derek.