Reply With QuoteThe only way I can think of is building it up with weld, and then turning it down to size again. Sounds overkill to me. Where's UK Neil when you need him? Off sunnin' himself, playin' with proper guns probably.
HRPC Hunter Field Target
Engineering help please
Hi all
The thread on my Logun pump has sheared infact its pretty much non-existant to be honestAnyway I have tried liquid metal , bearing sealer , PTFE tape all to no avail so it needs a new thread ! The base units thread is fine , its the small tube that sits inside the handle and outer tube btw .
As I am not getting any joy with replacement parts I wondered if the thread could be ' built up ' to allow a new thread to be cut ???
many thanks
Dave
]Never explain. Your friends do not need it and your enemies will not believe it anyway. ~ Elbert Hubbard[
Registered User
The only way I can think of is building it up with weld, and then turning it down to size again. Sounds overkill to me. Where's UK Neil when you need him? Off sunnin' himself, playin' with proper guns probably.
Weihrauch B&C HW95K, B&C HW35K, BAM B26-2 venoman custom, QB78 DL custom.
You ain't so big, you jus' tall, tha's all.
http://ukchineseairgunforum.myfreeforum.org/index.php
HRPC Hunter Field Target
Exactly what I thought but I am not an engineer by any stretch of the imagination ! lolOriginally Posted by uk litehammer
The only way I can think of is building it up with weld, and then turning it down to size again. Sounds overkill to me. Where's UK Neil when you need him? Off sunnin' himself, playin' with proper guns probably.
cheers
Dave
]Never explain. Your friends do not need it and your enemies will not believe it anyway. ~ Elbert Hubbard[
Registered User
Could you get the original part copied? It might be easier than fixing up the old part.
Weihrauch B&C HW95K, B&C HW35K, BAM B26-2 venoman custom, QB78 DL custom.
You ain't so big, you jus' tall, tha's all.
http://ukchineseairgunforum.myfreeforum.org/index.php
HRPC Hunter Field Target
Don't know if that would be viable but certainly worth a try I guess ?Could you get the original part copied? It might be easier than fixing up the old part.
atvb
Dave
]Never explain. Your friends do not need it and your enemies will not believe it anyway. ~ Elbert Hubbard[
I'm a Registered User, and I'm proud
Can you post a piccy?
When you get upset, remember it takes 42 muscles to frown, and only 4 to reach out the hand of friendship and extend your middle finger.
Never get out of the boat
Get a Dive Bottle.
Not much of an answer, was it?
1st Battalion Humberside Cavalier Rescue Deserters on the cut
Registered User
When you say "sheared", do you mean "stripped"?
Big difference.
The Bulletproof Monk
Send it back to Logun and make them fix it
A man can always use more alcohol, tobacco and firearms.
Registered User
Hi there,
These work very well!
I have recently used one to rethread the forestock to air resevoir thread (if you see what I mean?)
Here's a link
http://www.helicoil.in/http://www.helicoil.in/
If everything seems to be under control.........you are not going fast enough!
Captain Jack Sparrow
if it is the thread i am thinking about then a helicoil might not work as they are only any good in a blind thread bring it down the club on thurs and i will have a look and tell you plus weld wont work if it is alloy
ps not trying to teach you to suck eggs mate
Posting Permissions
