After buying overpowder wads on and off over many many years I have still to find an economical source of either 44/45 cal. cut wads or the material to cut them from. With commercial wads now at £5+/100 ther must be some enterprising member who has solved this problem?
Before you direct me to fillers! Please dont. I have been experimenting on and off for 30 years and i.m.o. wads are more accurate by small margin. But fillers will log up your revolver with crud 50/60 times faster wads. Since most all of the wad exits but some of the fillers will fly around the cylinder mechanisms.
I have experimented extensively on this subject. There will likely be challenges to this opinion I have no doubt.

But if you have a wad procurement solution I would be well pleased to hear it.

Also while I having my fivepeneth - I pre-grease my (Lead) balls with PURE Neatsfoot Oil to load over my wads. As opposed to filling the cylinder mouth. My gun hardly needs cleaning outside and inside with this method. Never had a trace of leading in the bore or forcing cone.
Sorry to waffle! Please advise your wad procurement solution!!