Idiots guide to classic airgun strips (pt 1)

[ggggr]

You can replace the piston rings with "O" rings as in Hawk mk 2 and 3 posts. Clean, lube and put back together. Put piston, spring and end cap back and replace cylinder end pin. Locate sidelever spring and sidelever and replace its pin and tighten the small grub screw up in the trigger block that pushes onto the pin (have a look at the block from the back where the sidelever goes). Replace cocking arm in its slot and line up with hole on sidelever and replace its pin. Replace the pawl and its spring and then the ratchet (and spacer) and pin and circlip. Replace loading tap, spring and lever and make sure the lever is pressed fully home before tightening its screw. Replace the trigger as in the Hawk mk 2 and 3 posts above (to save me time). Locate action in stock, checking you haven,t dropped that little metal locating dowel. Tighten both stock screws and replace sights.