been waiting to geta look at one of these for a while. It is very similar to the Slavia ZVP copy to strip.
Remove the sights if you want.
Undo the trigger guard screw and then unhook the guard from its pin and remove it. Remove the 4 grip screws. The action should now lift out of the grips. Watch out for the trigger spring, which will probably stay in the grips. Undo the cocking arm lock screw and pivot screw. Slide the cocking arm forwards until the pin lines up with the big hole in the trigger housing and then remove the pin. The arm should now slide out. Undo the barrel pivot lock screw and barrel pivot and remove the barrel and breech block. If you want to get to the plunger, Depress it a bit and unscrew the grub screw on the LHS of the breech block. The plunger and spring should now come out. Clean them, lube them and replace them and the grub screw.
Tap out the trigger pin and remove the trigger and then do the same with the sear.
Remove the small screw in the cylinder end cap. Unscrew the cap, keeping pressure on. When it is undone, the guide,mainspring and piston should come out. The piston has a leather washer set up held by a screw if you want to replace it.
Clean off your bits and go to part 2