This strip also applies to the vulan except it has a different piston head set up, "a ptfe set up and a rubber buffer" according to Phil Bulmer, which may be changed for a stingray set up on some vulcans,again according to Phil Bulmer.
Read previous post about problems with fitting big mainsprings and the gun not cocking. A quick strip guide can be found on thread "Webley hawk disassembley" 7/o7/08, post 3.
Remove sights. Remove front two stock screws and one in front of trigger guard. Remove action from stock. Remove cocking arm pivot roll pin and then remove cocking arm. Break barrel and depress barrel plunger and remove pivot pin. Release pressure and remove plunger and spring. Remove breech block and barrel. IF YOU ARE GOING TO CHANGE BREECH SEAL WASHER ON CYLINDER IT IS ALWAYS EASIER TO DO IT WITH BARREL OFF---ALSO APPLIES TO PISTOLS. BREECH SEAL SHOULD HAVE ROUNDED SIDE FACING OUT. Undo trigger adjusting allen screw on top of cylinder end block to take pressure off trigger spring. GO TO NEXT POST