Idiots guide to classic airgun strips (pt 1)

[ggggr]

This is for all the ones apart from the later trigger, which I havent seen yet. Firstly remove the little trigger adjusting screw and its spring that goes in the centre of the stock screw at the front of the trigger guard. Remove the two front stock screws. Remove the rear stock screw you have taken the adjuster out of. Lift action clear of stock.If you want to remove loading tap, you will need a screwdriver with a gap ground in the middle of its blade or gently punch the retaining nut on RHS of tap while holding tap to stop the tang breaking against the stop screw. This nut should unscrew and there is a spring behind it. When removed, the tap should come out.Undo cocking arm pivot screw and withdraw cocking arm (you sometimes have to push the leaf spring on it up against the bracket to do this). Undo cocking lever lock screw and cocking lever screw and remove lever. Remove trigger pins, trigger spring,trigger and sear. Push down on the endcap and the cylinder end pin should push out. Release pressure, remove cap and mainspring or springs should come out.( the original guns came with 2 concentric springs But these may well have been changed) GO TO NEXT POST