-
An idiots guide to Bsf 55 strip (pt1)
I got this a bit back but put off stripping it right down because I havent got a spring compressor yet and in the back of my mind was an old AGW article that suggested (on one of the Bsf,s) that a nut had been tightened by two fifteen stone Germans with a four foot spanner. I did the strip three times (so it must be easy) because the first spring I tried was coilbound even after cutting off a few coils.
Remove rearsight if you want. Its like the old Diana ones. Undo stock screw on underside of fore end and one in front of trigger guard and remove action from stock.If you look at the bracket that the cocking arms go through, you will see a pin. This needs removing and on mine was a right Ba*####*d----harder than the rest of the strip. Once removed,break barrel slightly and undo lockscew and pivot screw on RHS of breech block. You should now be able to remove barrel with cocking linkage attached. If you want to lube barel plunger and spring, they are held by a small screw on Rhs. Do it now and replace so you dont loose them.Unscrew cylinder end cap. Look at the scope ramp---the little screw at the back is just an arrestor for the scope and can be left in place. The big one at the front of the ramp needs removing or you cant get the trigger out. GO TO NEXT POST
Last edited by ggggr; 29-06-2009 at 06:20 PM.
Reason: error
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules