Idiots guide to classic airgun strips (pt 1)

[ggggr]

This strip will be easy for me to do. Remove sights and grips. Drift out barrel catch pivot if you want to grease it and the plunger. Remove pin at front of plastic cylinder sleeve and remove sleeve.Knock out pins at either end of triggr guard and remove it and the little sear spring. Remove the other pins one at a time to remove sear stop pin, sear,trigger and trigger spring. It then strips like the other Webley pistols. As the original link on this thread has been deleted, added a new one at the bottom. What I will say is this--follow the guide regarding the sear otherwise the thing wont cock (seen two with this problem). The easiest way Ive found to fit the safety catch is to just put it in with the cut out facing the back of the trigger and then fit the safety spring. The other thing is when you replace the endcap and guide, make sure the little plate the cocking arm pushes against is in place or the gun wont cock. I did that one Saturday night and then saw the bit in the tin put the bits in, DOH!
This guide should do the Hurricane and old Typhoon.
By the way--As these have the split ptfe washer, I have wound 1 turn of ptfe tape round the spiggot it goes on before replacing washer to save on getting new washer as the gun is just for plinking. Just trying this linky http://mediacdn.shopatron.com/media/.../131037909.pdf

If you fancy having a go at "tuning" the trigger then try this-

He is a bit about Tempest?Hurricane trigger fettling. Refer to these pics http://www.airgunspares.com/store/pr...t-Pistol-Sear/
http://www.airgunspares.com/store/pr...-Trigger-Wide/
I use 320 and 400 grit wet and dry paper to do them and they seem ok. With the sear, I polish both sides of the rounded bits on top, even though, the piston should not really touch them. I polish and try to take the angle back a touch more, the angled side of the cut out on the right of the picture. On the long leg I go the front face,the underside and the angled bit where it joins the back. (MORE ON THIS IN A BIT). On the trigger I do the flat face above the arc of the trigger blade, the face behind it and reduce the BUMP between that and the bit going up to the pin hole. This BUMP and the back bit of the leg of the sear are what "pauses" the trigger pull before releasing the piston. If you do a little work on the sear and the trigger, you can hold them in your fingers and rub one against another to get a good idea of this.Even with the BUMP on the trigger taken down a bit,I find slightly rounding the back edge of the sear helps. DO NOT GO MAD DOING THIS! Remember you can always have another go, but you cannot replace material.

A tuning link for the Tempest https://www.airgunnation.com/threads...r-tune.848192/


https://forum.vintageairgunsgallery....ebley-tempest/