Armex Reaper spares opinion please.

[deejayuu]

Thanks for looking. Several leaks, and verdigris on bolt/probe, on this one easy enough in the main but ptfe? exhaust vale seat leaking. Doesn't come in B&K kit and not listed anywhere I can find. Best opinion on how to proceed please.

[Shed tuner]

i'd strip it down and see if the valve seat might just respond to refacing.

[deejayuu]

Thanks for rapid response Shedtuner. Here it is hard and ridged . Seating looks good so hoping it's just this seal face.
Thought of spinning against fine emery board or last resort dig it out and insert something similar. Is Delrin an option please?

[Shed tuner]

delrin would be fine.. it's supported by the metalwork surround. But as you say, I think a spin with some emery (don't do too fine, it won't work) should ressurect it.

[deejayuu]

OK Will go for it. Thanks again.

[Neil54]

Looks very similar to the pvc seal on a QB78 series rifle.
If you can't smooth it out and seal it pm me and I will see what I have.

[deejayuu]

Looks very similar to the pvc seal on a QB78 series rifle.
If you can't smooth it out and seal it pm me and I will see what I have.

Thanks. May well need you later.