you can fit a new nylon piston seal from a asi delta. mine runs sweet on one.i think you might be hard done by to find the main frame.you got out to swap for mine im looking for a winter project.atb coddy.
Been given an old Asi Paratrooper repeater just like the one I had as a boy!! in 1978!!! but in a very sorry state , want to refinish the metle work barrle / cylinder ect need to fully get down to the bare metal any suggestions ? wire wool ect? and then reblue are the DIY cold blueing kits any good? then need a few spares piston washer breech seal ect any leads? then the biggie!! the main stock in cracked where the rear bolt securing the cylinder to the cast (body/stock). anybody got one thay want to sell or got any lead as to where I can find a replacment? or will this project be too costley?
Loved my paratrooper to bits years ago and always regretteted swaping it for my mates raligh chopper!!!
Cheers
you can fit a new nylon piston seal from a asi delta. mine runs sweet on one.i think you might be hard done by to find the main frame.you got out to swap for mine im looking for a winter project.atb coddy.
hi mate,you say its cracked around the rear securing flange at back,i do specialist welding etc i may well be able to sort it just cover postage ;i will treat it as a challenge,check how straight barrel is ive got very skilled at truing them up. thank old gggr on here he knows i cant resist a basket case .
regrds bob
[FWB124s]-[ORIG45]-[relum rescue ctr]
I CAN RESIST EVERYTHING EXCEPT AN FWB,