Sounds good. I usually put a little BP solvent down the bore, then do the soapy stuff much like you do.
Sounds good. I usually put a little BP solvent down the bore, then do the soapy stuff much like you do.
"I'm all in favour of keeping dangerous weapons out of the hands of fools. Lets start with typewriters." - Frank Lloyd Wright (1867-1959)
I've often thought that it would be nice if the time spent on cleaning could be less than the time spent on shooting....
Just pour boiling water over it straight from the kettle and scrub corners where dirt accumulate. The heat dries the gun quickly. Then lubricate thoroughly but not excessively.
Also find that a dedicated gun lube such as Browning's work a lot better at preventing rust than WD40.
if you use triple 7 or pyrodex its much easier to clean. I find BP gets very sticky.
I have a Ruger Old Army in stainless. Each time I shoot it I take out the cylinder, remove the grips and pour 1.7 ltrs (a kettle full) down the barrel and the cylinder scrubbing vigoursly the attached nipples.
Everyother time I shoot it (regardless of number of shots), I strip the gun to its components (including the nipples).
This takes about an hour or so but after 12 years my pistol still looks like new and I've never renewed the nipples.
Regards.
Brian
PS. I used Henry Kranks cheap sh*t (or anything else that was cheap!) for years but now use Swiss No. 1
Thanks for the imfo folks. Brian, you say you strip yours down to its component parts. Any idea where i can get write up on dissmantling a ruger old army. So far havent stripped mine down yet in case i cant get it back together. Tim
There's a fair set of instructions in the manual
http://www.ruger.com/Firearms/PDF/In...Manuals/13.pdf
Cheers
Roy
.