Hello, I have a BSF 55 belonging to a friend of my son, its in need of some trigger adjustment..
My question is, will there be any surprises like springs flicking out or ball bearings rolling around if I remove the trigger unit to clean it and replace the return spring?
Thanks for looking Dave..
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
Hi Ian, ok thanks for that.
I hope to get to your club in the new year all being well.. Dave...
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
Hi Ian, I have stripped the gun down a bit and found some things that don't seem right to me.
The cocking linkage appears to be bent and where it runs through a bracket mounted on the air cylinder, someone has packed it with some old plastic pieces as some sort of shims??
Pictures here..
http://www.pbase.com/davecthomson/image/120470022/large
http://www.pbase.com/davecthomson/image/120470030
http://www.pbase.com/davecthomson/image/120470051
Click on original to see in detail.
Looks a bit odd. Could the link have broken and someone has attempted to mend it? The gold coloured stuff ... could it be braze? I do not think it should be bent.
Looking at the Chambers web page for a diagram .. the cocking link is shown straight.
Not much help I am afraid ...
Cheers, Phil
HI Phil,
the gold coloured stuff is a combo of old grease and melted plastic from the packing in the bracket. I haven't removed it because I want the lad who owns the gun to see it first..Dave..
That linkage is deff. bent.
ATB
Ian
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
Hi Ian,
I was looking on Chambers site for a new cocking arm but they are out of stock. They do have some for the New model 55 but they look entirely different one piece with a separate shoe, so incompatible I suppose
What's puzzling me is why the packing? Also what would cause the cocking
arm to bend like that?
The next step is to remove the linkage and attempt to straighten it out. Can it be removed without taking the spring and piston out...Dave...
You will probably not be able to find a cocking lever, years since they were made. Although Manchester Air Guns just might have one.
It is a simple shape so one of the BBS engineers could probably make one up for you.
The bend is probably because of a loose breech bolt combined with an over-power spring.
Thanks for all the replies.
The plastic mess has been removed now, it looks like that expanding foam stuff
The young lad who owns the gun came to look at it last night and its been decided to attempt to straighten the linkage out, but first we have to remove it so any tips and advise would be very welcome.
Mally, thanks for your kind offer, if things go awry I will be in touch
Once again Many thanks to all on this very helpful corner of the forum
Seasons Greetings to one and all Have a good one..Dave..
Personally I would fully strip the rifle to see what other damage has been done. It may be beyond financial repair if the internals are similarly knackered.
The rifle are fairly straight forward to strip once youve learnt the 'BSF Secret' which is the scope rail (one screw) must be removed at the same time the end block is released - preferably in a spring compressor.
ATB
Ian
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
I have a couple of new ones spare if you get stuck