Sheridan where when and how!!!!!!!!!

[dannyg001]

hi guys looking for some info on these rifles, any ideas where i can lay my hands on one of the 70's to 80's models preferably in .20 cal any help would be greatly appreciated cheers danny

[JSD]

hi danny, did you ask gedfinn2 on here ? a.t.b. J. S. D.

[dannyg001]

no mate, who is that im new here youll have to excuse me atb danny

[JSD]

hi danny, gedfinn2 is a member on here, his knowledge of
pump ups is excellent.. send him a pm, kind rgds.. JSD...

[T 20]

70's to 80's models preferably in .20 cal

Hi Danny

They only came in .20" flavour in the 70's and 80's.

If I have anything in PDF I'll send it to you.

All the best Mick

[dannyg001]

cheers mick thanks a lot mate

[josh t]

im new to this 2 but i have an old sheriden it is 20cal but barrel is loose

[gedfinn 2]

im new to this 2 but i have an old sheriden it is 20cal but barrel is loose

Hi Josh, Its a tricky process but can be done !
Usually they are only good for spares, In the USA its a scrapper, Its usually caused by the fitting of the telescopic sight mounts ! Williams peep only for these.

However, It must be stripped down completely & the barrel taken off, cleaned up & re-soldered on.
Sounds simple, but here is the problem, The exhaust valve body is crimped in the main tube & then soldered, Its the melting of this solder ( And the ruining of the gun ) that is the problem, Also the finish is gone, It needs re-blacking,
Pretty easy on brass but still work.

I have done about 6, or 7, & cocked one up, !!!
I have a new approach now, Ha ha, Its close to 100 % but !
Here are some I did last year,
Setra .22 barrel on a Sheridan

3 or 4 Sheridans & a Benjamin

Cheers, Ged