....just posted a large post on stripping the Jackal under Kingplinkers Thread .
These are all the same design action and chamber ....
ANOTHER PROJECT!
Could anybody tell me what i need todo to strip it down. Ive looked on the chambers site and it looks like a pin with a groove in is holding the back block, after Ive taken the grub screw out. Looking at the top of the gun it looks like somebody had a good time before.Of course they have put a square spring in. I want to send it backto normal,its only punching 7 1/2 lb at the moment,with alot of recoil.
Also the butt has a crack in it if anybody has one cheap for a camargue,bora or mistral?!!! thanks everybody who helped on my last project, looking forward to this one! phil
....just posted a large post on stripping the Jackal under Kingplinkers Thread .
These are all the same design action and chamber ....
Last edited by Arch.Stanton?; 18-02-2010 at 08:04 PM.
" WHEN YOU'RE GOING TO SHOOT - SHOOT , DON'T TALK ! "
http://www.airgunforum.net/agf/index...c=4822&hl=SE90
Try this guide, you have to register on the forum if you're not already a member.
Get rid of that spring as well. Make sure the loading tap isn't loose, if it is you'll lose a lot of power due to air leaking past it.
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
tried the links but they all seem to be broken or out of date.
http://www.airgunforum.net/agf/index...2&hl=sidelever
Try this one.
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
there's a little grub screw on the side that holds the main pin in
you have to take that out before you do any thing