A big update today.

All the electronic bits are now together.

http://s699.photobucket.com/albums/v...get%20Project/

Lots of pictures in the above link.

This is the Rika target holder which has been modified to fit on top of the servo.

http://i699.photobucket.com/albums/v...Project034.jpg

http://i699.photobucket.com/albums/v...Project032.jpg

http://i699.photobucket.com/albums/v...Project039.jpg

http://i699.photobucket.com/albums/v...Project045.jpg

I drilled the Transmitter box today and installed the pushbuttons and screen. Then I had to make up a small PCB with the pull down resistors for the pushbutton inputs. This is to stop the Arduino board from detecting a floating voltage input which would cause all sorts of false input readings.

http://i699.photobucket.com/albums/v...Project057.jpg

I messed up the LCD slot cut-out a little. Always measure twice and cut once. I think I will look for and aftermarket bezel to hide the small gap.

http://i699.photobucket.com/albums/v...Project048.jpg

The rear of the main panel.
http://i699.photobucket.com/albums/v...Project066.jpg

Connected.
http://i699.photobucket.com/albums/v...Project072.jpg

Finished Transmitter and Receiver Boxes.
http://i699.photobucket.com/albums/v...Project100.jpg

Complete System.
http://i699.photobucket.com/albums/v...Project088.jpg

At the club tomorrow, one of my fellow committee members will hopefully cut the 60mm aluminium box section that will hold the servos.

Thanks

Mark