Snider-Enfield parts wanted

[Tantomurata]

Wanted for two-band Snider-Enfields.

Clearing rod (ramrod). The type that has the squared jag end, not the round profile. (2 required)

Rear-sight ladder or just the slider bar. (1 required)

Original parts only please, not repro or Nepali, and without WD markings.

[Andy Mac]

Have you tried Peter Dyson he has some original parts.

http://www.peterdyson.co.uk/

[Tantomurata]

Have you tried Peter Dyson he has some original parts.

http://www.peterdyson.co.uk/

Thanks Andy for the suggestion. the last time I tried Dyson he didn't have any original 2-band rods or swivels and he only sold complete rear sights. His website still shows the swivels as out of stock.

[RogerH]

Wanted for two-band Snider-Enfields.

Rear sling swivel. The type that screws into the buttstock. (2 required)

Clearing rod (ramrod). The type that has the squared jag end, not the round profile. (2 required)

Rear-sight ladder or just the slider bar. (1 required)

Original parts only please, not repro or Nepali, and without WD markings.

What about IMA in the States.

http://www.ima-usa.com/index.php/cPa...733ba3c1128097

[Tantomurata]

What about IMA in the States.

http://www.ima-usa.com/index.php/cPa...733ba3c1128097

Roger thanks for your post. Unfortunately most, (if not all) of IMA's Snider-Enfield stuff is Nepali. I have one of their 3-band ramrods. The rod is not parallel and you can see fold lines in places where the rod has been hammered into a round(ish) section.

I'd rather wait and buy exactly what I want either from an individual or at an arms fair, and not compromise on getting the correct parts.

[njaw]

Hi there

You need to speak to a chap called Graeme Cole. He will have all the spares you are looking for. He can be contacted here:

graeme@graemecole.freeserve.co.uk

regards

Nick Wright

[Tantomurata]

Hi there

You need to speak to a chap called Graeme Cole. He will have all the spares you are looking for. He can be contacted here:

graeme@graemecole.freeserve.co.uk

regards

Nick Wright

Thanks Nick, I've emailed him.

[Tantomurata]

Graeme was able to supply the swivels. I'm still looking for the clearing rods and rearsight slider (or ladder and slider) as in post 1 above.

[Tantomurata]

Wanted for two-band Snider-Enfields.

Clearing rod (ramrod). The type that has the squared jag end, not the round profile. (2 required)

Rear-sight ladder or just the slider bar. (1 required)

Original parts only please, not repro or Nepali, and without WD markings.

This is the type of rod I'm looking for;
http://i766.photobucket.com/albums/x...dAlbinicle.jpg