Whilst sorting through my junk in the attic I came across these home made pellets in .22 from a few years back. They weigh in at a very consistant 19.7 gns and measure .222 diameter. As I recall I made a female die by drilling a piece of steel on the lathe and fitting a male ram into the back. This all fitted into a Wamadet (remember him?) press. The filling was fluxless 1/8in solder wire.

http://i971.photobucket.com/albums/a...G/DSC_6337.jpg

I was going to show you a nice tight group shot at 50 yards, but the "pellets" wouldn't fit into either my AA410 or my HW80, even with a hammer.

Oh well! Back to the drawing board.