Morini Reseal?

[Eddiekneejerk]

Hey Again,

My Morini leaks air very slowly and the catch which holds the breech closed if the pressure's too low wont disengage when I put a full cylinder on, so I reckon it's in need of a reseal and perhaps a general service.
Does anyone know where I can get it done?

[Cones]

Morini can supply you with a seal kit.

I did my own and thought it was not too difficult to strip down.

But mine did have the fixed air cylinder.

I am sure several of the good match pistol suppliers in the UK will be able to help as well. Perhaps City AW in Solihull?

HTH

Mark

[hwtyger]

A general tip; IF you sent it to morini for service (which I did) sent it under 're-import'. If you dónt, you'll pay import taxes etc!!cause Swiss is non-EU!

[The Doctor]

Contact Peter at Surrey guns - he did one I had

Lee

[Eddiekneejerk]

Thanks for your replies chaps, a couple of good leads there.

[harvey_s]

I think Iqbal Ubhi is a Morini agent too...
There is a contact no. for him on the club notice board, but I don't have it to hand although someone else on here might...