ProTsc-1911 - Hands On

[timtriple]

Hi Dave

It was about 3 times every tens shots (ie every mag full) and as said tried two makes of ammo with same result

Tim

[davederrick]

I'd suggest stripping it & make sure there are no signs of excess rubbing. The slide will probably bed down after a bit, but it should have a small amount of lube on it.

[timtriple]

Well stripped it gave a good oiling then today not confident in taking it down one of local clubs so drove down to The Tunnel where Richard made me most welcome and tried it. He fired off 30 rounds no problem then left me to get through another 200, fed and fired faultless apart from a couple.

Richard said just like having a new car with a rattle when you take it back to dealers?

We think maybe sticking firing pin due to be new and oiling freed it up.

It was great fun, tried with cheap standard velocity and mini mag, now to work on accuracy

[davederrick]

Good-oh !

[ShootingChannel]

Dave,

Have you found any issues with your barrel retaining screw loosening up? The thread on my screw completely stripped and we had to use helicoils to fix it. Now that screw has been loctited in.

What sort of grouping can you get at 25yards? The best ive managed is about 3-4 inches.

[Westcountry Tony]

that barrel retaining screw will come loose and damage the soft threads if the barrel can move

Im sure I have already mentioned it, but anyway. I stripped mine and wasnt happy with the fit, nor with the flippant answers I had read concerning, just keep tightening it, thats not a solution in my opinion

so I experimented, I found that by using small pieces of insulation tape stuck to the barrel, I could get the barrel to be a snug fit, this means that it cant move about, and hence the screw cant come undone

since putting mine back together its had somethign int he region of 3k rounds thru it, not once have I had to even look at the barrel screw, also if you grab hold of the barrel on mine, it wont move up and down like a lot do.

only thing I have done is remove the mag safety.

soon as I got some spare cash I will be putting new sights on it.

with regards to accuracy mine rested on the bench and a rolled up bit of carpet will shoot 1-1.5" groups at 25m, hoping to get a red dot on there and then see what its like.

[davederrick]

I was having too much fun practising double taps to notice grouping
Good tips from Tony about the screw, will try.....

[boff180]

that barrel retaining screw will come loose and damage the soft threads if the barrel can move

Im sure I have already mentioned it, but anyway. I stripped mine and wasnt happy with the fit, nor with the flippant answers I had read concerning, just keep tightening it, thats not a solution in my opinion

so I experimented, I found that by using small pieces of insulation tape stuck to the barrel, I could get the barrel to be a snug fit, this means that it cant move about, and hence the screw cant come undone

since putting mine back together its had somethign int he region of 3k rounds thru it, not once have I had to even look at the barrel screw, also if you grab hold of the barrel on mine, it wont move up and down like a lot do.

only thing I have done is remove the mag safety.

soon as I got some spare cash I will be putting new sights on it.

with regards to accuracy mine rested on the bench and a rolled up bit of carpet will shoot 1-1.5" groups at 25m, hoping to get a red dot on there and then see what its like.

Tony could you post some photos on where to put the tape please?

Thanks

Andy