Demic, miserable, grumpy old git! Feinwerkbau Sport Appreciation Society.
I don't mind what sexual, religious or political persuasion you are, just don't impose them on me!!
In which case the screw version may fit as well? Here's a parts diagram showing the screw version.(And unshrouded barrel).
Would a 300 unit fit? I don't know the corresponding barrel diameters from memory. There's more likelihood of finding one of those, 150 spares are few and far between.
Here's a link to Garvin's post with a scan of the 150 instruction manual if you haven't seen it, just for interest.
Thanks for the info 18 Wheeler, much appreciated!
I need a couple of the wrap-arounds to fit early 124's.
ATB
Eric
Last edited by Herpquest; 26-06-2011 at 03:36 PM.
Demic, miserable, grumpy old git! Feinwerkbau Sport Appreciation Society.
I don't mind what sexual, religious or political persuasion you are, just don't impose them on me!!
You're welcome.
Lovely rifles, full of innovation and a piece of history in many ways.
Although they don't actually list the foresight, this might be a company to contact. They do carry a wide range of spares.
Rutty
A few more links,
- This shows the two 150 variants, mine with the wedge/pin is the same as that in the lower two photographs, butting up to the straight shroud, with a small portion of just barrel protruding at the front.
The top two pics show the screw/clamp arrangement.
-Waffencentre have this type for the FWB300 (in this case one of three variants), not identical but similar.
If you end up considering fitting the 300 model I can measure mine up and/or compare it with a 300 model from another club shooter to see if they are interchangeable.
Good luck in your quest