Remembered the spring? Other than that did the bar fit back in ok befor you repeged the trigger into the block.
Just rebuilt my TX200 all is fine apart from the safety has stopped working - any ideas?
Remembered the spring? Other than that did the bar fit back in ok befor you repeged the trigger into the block.
Set Bazookoids to kill stuff and mount. We're going in!
Did'nt strip the trigger assembly?
TX's need that last bit of pull on the lever to set the safety. If you've fitted a new spring, it might be on the edge of getting coil bound. The piston is engaging the sear, but not going far enough back to set the safety.
Gus
The ox is slow, but the earth is patient.