Results 1 to 2 of 2

Thread: Westlake Taurus Conversion

  1. 19-07-2011, 11:39 AM #1
    Rollo
    Rollo is offline Registered User
    Join Date
    Jan 2011
    Location
    Birmingham
    Posts
    521

    Westlake Taurus Conversion

    I was wondering what sort of results people have had with the Westlake Taurus nitro muzzle loader ?

    Are there any issues with the bullets moving under recoil - I'm assuming there is no ring of lead shaved off when seating so just wanted to confirm that the heads are nice and tightly seated.

    What sort of accuracy are people getting ?

    Are there any issues with light strikes ? When I had a Taurus LBR it wouldn't reliably ignite anything other than Federal primers
    Last edited by Rollo; 19-07-2011 at 12:15 PM.
    Reply With Quote Reply With Quote
  2. 19-07-2011, 02:27 PM #2
    Wobbly 2
    Wobbly 2 is offline Registered User
    Join Date
    Feb 2008
    Location
    Shepperton
    Posts
    484
    I have never had problems with the bullets moving under recoil.

    I'm using Speer hollow based wadcutters, and it shaves off a tiny amount of lead when loading the bullet into the cylinder.

    Never had a problem with light strikes, I use Cheddite primers, without any problems, I did try Remingtons which were ok, but CCI's didnt seat right, so could not recommend them.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules