Following on from Hsing-ee's thread in the general section about oversprung guns, whats the worse/best you have seen/done or heard of?
seen a fair few guns with jubilee clips round them when the front stock screws have stripped. seen plenty of self tapping screws as well. Lots of panel pins and small ball bearings in piston washers. A few cut down barrels that have been cut at an angle and left like that without even filing (I hate to cut barrels and have only done it to clean up previous cuts. Luckily the guns have shot ok each time ) seen nails and wood screws used as pivot pins.
I asked a shop what was the worse one that they had seen. The answer was a cut down Relum Tornado---with the cocking arm shortened as well .
Over to you.