MTC viper 10x44

[tazzer666]

Hi due to your review i myself have purchased the viper and on first few tries with it im chuffed, got to agree with the op about the turrets being a bit hard to push down at times

[silver fox]

turrets are tight but at least you know they're not going to move on their own, have fun they're a great scope, got two meself.

[cocoamedia]

Thanks for the review.. I have one arriving any day for stating out in HFT

[pward]

Does anyone use these for hunting?

ive used for hunting and there exceptional scope all though a little heavy they really do represent great value for money when you compare to others in the price bracket,theres nothing ive seen through will touch these,you do get alot of kit for your money with the mtc range, ive noticed out of alot of scopes they do push the boat out when packed too, so there nice and safe when you get them,theres alot of extras with these you just dont get with other scopes

[simes222]

I have just fitted a 10x44 to my TX , does anyone else have one on a springer and has it stood the test of time?

[Wryka]

I have just fitted a 10x44 to my TX , does anyone else have one on a springer and has it stood the test of time?

I spoke to gary about this and he told that the scope is more than capable of springer abuse. I think read somewhere that they were fine on rimfire as well.

Wryka

[bassangler]

Does anyone use these for hunting?

mine is on my rapid7 .22 i hunt every week with it ,its a deadly combination ,cant fault it , i ranged & worked out the mill dots & have killed a maggie at 86yds sub 12 plus numerous pigeons at 70 plus

[Steven842]

I got one on my tx200 awesome scope so easy to set up

[Rex&Amy]

Thanks for the review guys as I was thinking of changing my 4-16x50 viper for the fixed 10x44 as my aim points can catch me out when i am trying too hard and also the fact that I have a damper mount on it. when zeroed at 30 yds 8 yds seems a bit mad as its 3.5 mildots and then 15 is half with the change over at 17 then just above cross hairs at 20, then cross hairs until 30. it has cost me a few points and also i cant really rest my cheek against the cheek piece with that set up. I was going to sell it on and buy the 10x44.

Had a conversation with Sammy at MTC today and she was a fantastic help and discouraged me from the expense and suggested trying lower mounts. I have checked the clearance i have. At present my mounts are 20mm high and it has 6.2 mm clearance at the lowest point of the scope. I am now trying to find the right scope mounts as close as i can to 14mm to address this and feel optomistic that this is going to help address my inconsistencies in my shooting.

Basically I think I have too much to think about before pulling the trigger as I tried good old uncle Harry's gun on sunday and it seems so easy compared to mine to get consistent shots. Basically I have to just touch the side of my chin against the same place on the cheek piece which doesnt lend itself for the best set up when your doing hft. Now I have the job of trying to find 30mm mounts with arrester screw that the manufacturers give the exact height. any pointers would be great.

[Rex&Amy]

I thought I would let it be known that I was informed by those that had tried what I was trying to do that it would not work as the gap was so minute. So I have now changed the scope to the 10x44 and it feels so wonderful. I am very hopeful that I have now got Amy well sorted ready for some seriously rewarding HFT shooting.