-
martini henry reloading
need some advice or i may need a new press perferably a lee cast iron one.
basically my orange crusher is not set up for these big lee dies as such.....the top does screw off so the dies will screw in but when i need to use the dies they have to be screwed right down so the locking ring comes off the threads esp when i need to enlarge the necks.....i think the top of the frame is too thick at 3cm where as my challenger press is 2.5 cm
anyone as had this issue or do i need a ram extender ?
Last edited by loiner1965; 21-01-2012 at 12:35 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Reply With Quote