Is it possible to fit screw in swivel studs to a Raptor with a skeleton stock?

i contacted falcon and they told me it was not. i have had a look at the stock on my raptor and if i shorten the lower butt plate screw i should be able to fit the rear one.

the front one looks a little more worrying, as it would have to go in front of the front fixing band screw. and would be within 8mm of were it goes through the stock at the closest point, and 11mm at the largest point.

I'm also a bit worried about the stock cracking at the rear under the stress of the rifle being carried while using a sling.

does anyone think that it can be done, or have you done it yourself?

thanks
scott808