The problem is getting the entire front end off. Richard said that to replace one of the seals on the cylinder head (not piston head) I would have to remove the outer barrel and inner barrel (part marked A on the photo), and the bolt assembly (part marked B). Then I would have to remove the valve and the piston assembly and then tap the cylinder head out of the front of the action.
I have no problems with getting the piston or the valve out, but getting the bolt action out with the outer barrel is a complete mystery.
Last edited by Duff Beer; 09-01-2009 at 08:45 PM.
Now with added Feinwerkbau 127
In the beginning was the Genesis; it is the first and the last, it is the truth and the light, it shooteth straight when others fail. - Pagoda113
Reply With Quote