Results 1 to 15 of 18

Thread: Relum LG 522

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Relum LG 522

    Been sent here by the good guys in general section, anyone help me with hints on tuning an LG 522, shoots ok but not a lot of power? i know there not powerful to start with, but can i rework this gun? kind regards Mick
    Last edited by mickmick; 27-09-2012 at 06:50 PM.
    mickmick
    fas est ab hoste doceri

  2. #2
    Join Date
    May 2008
    Location
    Quigley Hollow, Nuneaton
    Posts
    17,111
    Quote Originally Posted by mickmick View Post
    Been sent here by the good guys in general section, anyone help me with hints on tuning an LG 522, shoots ok but not a lot of power? i know there not powerful to start with, but can i rework this gun? kind regards Mick


    Hi Mick

    I think the LG 522 is also known as the Relum Telly and is basicaly the break barrel version of the Relum Tornado.

    I've just been given a Relum Telly so I'll be tuning this in a similar way to the Relum Junior I did a couple of years ago, ie ---

    I'll replace the piston seal with an O ring piston head - though an adaptor and a Weihrauch 26mm seal can also be used.

    The tit on the back block will be machined off so that a top hat type spring guide can be used - an old meteor one could be used if on a budget.

    For the mainspring I use a single spring and guide instead of the original twin spring setup --- normally a Meteor spring does the job.


    This is all from memory so if I get five in the morning I'll strip my Telly and see if anything else could be done or if a different spring would be a better fit.



    Last weekend I was playing with a new Walther LGV --- this weekend I'm playing with a Relum Telly.

    At least I can't be accused of being a gun snob.








    All the best Mick

  3. #3
    Join Date
    Apr 2012
    Location
    Plymouth
    Posts
    85
    I've got a Hungarian LG522, Which I bought from a junk shop about 25 years ago. I've "googled" pictures of a Relum Telly.... but mine has very little resemblence to a "Telly". Were there varied models made?

  4. #4
    Join Date
    Apr 2012
    Location
    Plymouth
    Posts
    85
    Quote Originally Posted by lesj View Post
    I've got a Hungarian LG522, Which I bought from a junk shop about 25 years ago. I've "googled" pictures of a Relum Telly.... but mine has very little resemblence to a "Telly". Were there varied models made?
    Just "googled" a bit more....... Seems my gun is an LG522, but with what seems to be an LG24 stock.

  5. #5
    Join Date
    Mar 2012
    Location
    Near Auckland
    Posts
    1,303

    Cool

    Quote Originally Posted by lesj View Post
    Just "googled" a bit more....... Seems my gun is an LG522, but with what seems to be an LG24 stock.
    Do you have an image of yours??

    Some info that I came upon while searching for details and identity of what turns out to be a FEG 877. The only stamp is I.D LP22 and the serial number with the grooved stock.
    I like them, they are solid and functional.
    http://smg.beta.photobucket.com/user...tml?sort=3&o=3

    Relum Jelly LP 25 (or Telly with a German T on the disk that is/was on the stock).
    One of a number of break barrels that were made for Relum by the Hungarian FEG armaments factory.
    They also made a a smaller break barrel, the 822 LP23 0.22” and 877 LP22 .0.177”.
    In the 70s these models were dropped for a new range of guns, the 422 (Taurus), 522 (Rapide) and 527 (Zephyr), the last of which is still in production.

    Relum (Muller) also imported guns form other E European countries and relabeled them.
    Last edited by slow_runner; 29-09-2012 at 08:06 AM.

  6. #6
    Join Date
    Apr 2012
    Location
    Plymouth
    Posts
    85
    Quote Originally Posted by slow_runner View Post
    Do you have an image of yours??

    Some info that I came upon while searching for details and identity of what turns out to be a FEG 877. The only stamp is I.D LP22 and the serial number with the grooved stock.
    I like them, they solid and functional.
    http://smg.beta.photobucket.com/user...tml?sort=3&o=3
    The actual gun is exactly like the metal in your photo. It is stamped: LG522 made in Hungary. There is another serial type number: 10(or C)252 The trigger guard is identical. Iron sights are long-gone Im afraid.
    On the photo of the collection of guns, the stock is very similar to the second one down. However, instead of the end of the fore-grip being at right angles to the cocking arm, mine is raked-backward (not forward).
    It is of an unusual woodgrain(stained quite dark). The underneath of the foregrip is very flat. No sign of a "Telly" disc indication.
    Last edited by lesj; 28-09-2012 at 09:10 PM. Reason: addition

  7. #7
    Join Date
    May 2008
    Location
    Quigley Hollow, Nuneaton
    Posts
    17,111
    Quote Originally Posted by lesj View Post
    Just "googled" a bit more....... Seems my gun is an LG522, but with what seems to be an LG24 stock.
    Hi Les

    I've just had a google and found this, I think it's part of I.J.'s collection.


    http://i26.photobucket.com/albums/c1.../FEG/FEG12.jpg


    God knows what Relum I have.

    I'll have another look in the morning, I may even put a photo of it on here for a laugh.





    All the best Mick

  8. #8
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Rapide

    Quote Originally Posted by lesj View Post
    Just "googled" a bit more....... Seems my gun is an LG522, but with what seems to be an LG24 stock.
    Hi mate your gun is the same as mine it's called a "Rapide" hope you still have it? regards Mick G
    mickmick
    fas est ab hoste doceri

  9. #9
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Hungarian

    Quote Originally Posted by lesj View Post
    I've got a Hungarian LG522, Which I bought from a junk shop about 25 years ago. I've "googled" pictures of a Relum Telly.... but mine has very little resemblence to a "Telly". Were there varied models made?
    Yes mine says Hungarian on it too, regards Mick
    mickmick
    fas est ab hoste doceri

  10. #10
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Photos Please

    [QUOTE=T 20;5665133]Hi Mick

    I think the LG 522 is also known as the Relum Telly and is basicaly the break barrel version of the Relum Tornado.

    I've just been given a Relum Telly so I'll be tuning this in a similar way to the Relum Junior I did a couple of years ago, ie ---

    I'll replace the piston seal with an O ring piston head - though an adaptor and a Weihrauch 26mm seal can also be used.

    The tit on the back block will be machined off so that a top hat type spring guide can be used - an old meteor one could be used if on a budget.

    For the mainspring I use a single spring and guide instead of the original twin spring setup --- normally a Meteor spring does the job.


    This is all from memory so if I get five in the morning I'll strip my Telly and see if anything else could be done or if a different spring would be a better fit.



    Last weekend I was playing with a new Walther LGV --- this weekend I'm playing with a Relum Telly.

    At least I can't be accused of being a gun snob.


    Any photos of the gun stripped down would be handy, if you could email them, mickglynn1@talktalk.net, kind regards Mick
    mickmick
    fas est ab hoste doceri

  11. #11
    Join Date
    May 2006
    Location
    rustington/littlehampton,riviera of the south
    Posts
    2,506

    reply

    as you say these are always going to be relatively modest in output but to get the best out of them is really as already stated by posts above;
    over powering is nearly always a mistake,the meteor spring replacement is the most advantageous then replacing all the performance related parts
    like breech seal and piston seal,the piston seal in leather is an overlooked item in terms of performance and yet very simple to get the best from.
    both sides of the excess can make a noticeable reduction in output;a lesson a friend learned when rebuilding his much loved airsporter ,it was what we thought at the time a little to tight and even when a fair number of running in shots were fired power was down ,after a tad was removed from the sealing faces re lubed and she was running at full power consistantly ;the other often detail overlooked by newbies is the pellet choice.at the "range" a demonstration of a wide variety of ammo in 3 very different airguns with a detailed chrono check was an eye opener for me returning to the sport .and showed me to overlook this can spoil even a quality mark.
    [FWB124s]-[ORIG45]-[relum rescue ctr]
    I CAN RESIST EVERYTHING EXCEPT AN FWB,

  12. #12
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Thanks

    Thanks to all who replied, and gave all the information very pleased and thanks again, regards Mick
    mickmick
    fas est ab hoste doceri

  13. #13
    Join Date
    May 2008
    Location
    Quigley Hollow, Nuneaton
    Posts
    17,111
    Quote Originally Posted by mickmick View Post

    Any photos of the gun stripped down would be handy, if you could email them, mickglynn1@talktalk.net, kind regards Mick
    Hi Mick

    No photos of the gun stripped yet --- I was a bit busy setting up match ploughs yesterday, but I did manage to take some pictures of my Telly.

    http://i1138.photobucket.com/albums/...0012006661.jpg

    http://i1138.photobucket.com/albums/...0012006663.jpg

    As you can see it must be a rare factory camo edition --- I can't believe anyone would be daft enough to give this away.

    As for stripping instructions these may help.

    http://www.gunspares.co.uk/shopdispl...482&cat=Taurus

    http://www.gunspares.co.uk/shopdispl...&cat=Telly+200




    All the best Mick

  14. #14
    Join Date
    Sep 2007
    Location
    Doncaster South Yorks
    Posts
    656

    Thanks

    Quote Originally Posted by T 20 View Post
    Hi Mick

    No photos of the gun stripped yet --- I was a bit busy setting up match ploughs yesterday, but I did manage to take some pictures of my Telly.

    http://i1138.photobucket.com/albums/...0012006661.jpg

    http://i1138.photobucket.com/albums/...0012006663.jpg

    As you can see it must be a rare factory camo edition --- I can't believe anyone would be daft enough to give this away.

    As for stripping instructions these may help.

    http://www.gunspares.co.uk/shopdispl...482&cat=Taurus

    http://www.gunspares.co.uk/shopdispl...&cat=Telly+200




    All the best Mick
    Thanks for allt he help T20, and good luck with the ploughing? kindest regards Mick
    mickmick
    fas est ab hoste doceri

  15. #15
    Join Date
    Mar 2012
    Location
    Near Auckland
    Posts
    1,303
    Quote Originally Posted by T 20 View Post
    Hi Mick I did manage to take some pictures of my Telly.

    http://i1138.photobucket.com/albums/...0012006661.jpg

    http://i1138.photobucket.com/albums/...0012006663.jpg

    As you can see it must be a rare factory camo edition --- I can't believe anyone would be daft enough to give this away.

    All the best Mick
    Niiice.
    Mick, that must be the special edition for combat exercises in the missus' flower bed

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •