New and confused

[peteswright]

Hi peteswright,

I used some fine emery on the sear and hammer contact faces and used a bit of graphite grease. It doesn't seem to need much smoothing, when I first tried it, it was truly a hair trigger.

I thought the screw thread was M4, but it is actually the same thread used on screws for light switch and socket plates...

The one thing I nearly messed up was other end of the sear spring, there is a small plastic washer over the coil that flipped off and was nearly lost! Other than that, taking out the two main parts was very straightforward.

Happy tweaking!

Cheers, M.

Thanks for the reply. I know about the light switch screw, even tried it but it made trigger pull shorter which I didn't want. Might try the emery paper if you reckon its an easy mod, although I have got used to the trigger as is. Pete.