Hi All,

Is it just me, or do other people have trouble making sure the scope reticule is dead vertical / horizontal

Obviously if you get it wrong then the poi is going to be out horizontally / vertically, at ranges other than your zero point.

I wondered if the scope manufacturers could put an engraved line down the top of the scope and scope mount manufacturers mark the exact middle of the top mount section, it would make fitting a new scope so much easier !

I also have a design on paper for a new ( I think )
type of scope mounting system but I'm not sure if any scope manufacturers would be prepared to try it out. It would eliminate the above scope problem, allow infinitely different scope heights without changing the mounts, eliminate scope tube nipping and could even incorporate rubber shock absorbtion as well. ( all from one kit )

If a scope manufacturer took it on they'd have to make the mounts as well though.

Does anyone know who the most approachable, innovative scope makers are?


Norm