Hiya!
.it looks like no-one else has heard of of 'em either.Why don't you tell J.T. they're the best thing since sliced bread .Then he'll go and order one and you can have a shot of it !
See ya O.
Has any one on here had experience with the Lothar Walther polygonal barrel on a FT or HFT or benchrest air rifle?
How do they compare for accuracy with a LW button rifled standard barrel?
These barrels are available and not too expensive to buy and retrofit to a good PCP but are they any better than a conventional rifled barrel
hold me back !!
Hiya!
.it looks like no-one else has heard of of 'em either.Why don't you tell J.T. they're the best thing since sliced bread .Then he'll go and order one and you can have a shot of it !
See ya O.
See this link, scroll down there`s a section written by John Whiscombe.. http://www.network54.com/Forum/79537...+is+the+best--
Hi Owen
I already have sown the seeds and if his HW barrel is not very good then he may well try one
Nick M has one but says it is very similar accuracy to his standard barrels
If they were a direct fit onto the EV2 or MPR then I would buy one but the breech will need machining and cleaning up the TP hole may be difficult
ATB
John
hold me back !!
Slightly off topic but I feel relevant.
Some of the most accurate barrels produced were on PRE UMAREX Hammerli's, SO, who made them? ......GAMO! Don't quote me ask him, I THINK Hareng (Jon) on here famous for his FT conversions has used them on his own rifles too!
IF IT'S NOT BROKE.........DON'T FIX IT!
Hi,
This HW100 has a Lothar Walther polygonic barrel. It's used succesfully for 100m matches.
Some results.
ATB
emi
100mairgun.nl (TRANSLATOR on top! )
This has been asked before on this forum, do a search on polygonal and it'll all be explained.
Hth
Vasbyt
Gas operative extraordinaire