Different Targets

[EV2UK]

Hello, I'm board and was thinking about what you could make for a terget as a guy at my club is a fabricator and we were thinking about what he could make up as a target..

A spinner on a threaded rod about a meter long, start the spinner in the middle two shooters with single shot rifles (or both with mutishot) on shoots the top and the other shoots the bottom first to their side wins (good a)

Any other sugestions

[delta1]

Make a couple of those, with the thread vertically.
First to the top wins.

I am currently looking at non animal shaped knockdowns, faves so far are gatso, lightbulb and bottle.

[Northernspark]

How about a target in the shape of.........Tony Blair

Steve

[Steyr]

Wouldnt work - too much wind

[Steyr]

BUT.........if you got prescott to stand behind him - a hit every time

[delta1]

If you wanted a T Bliar target you could make the smile the killzone.

Never miss!

Edit if the smile was 40mm just think how small the target would be?

[Gwylan]

A horizontal rod is fairer, no gravity assist for the one winding down! About 30 cm. is enough, I used studding bar (?), and added a little spring loaded flag which popped up on the winner's side...! Good fun..!
Gus.

[delta1]

I was thinking of two identical targets but horizontal would work better if a single target was used.

[Young_Gun]

Fun one is getting the ring of 8 caps from cap guns and cutting them into seperate ones.
Stick 'em up and shoot 'em at dusk or night and watch them pop.
An old Co2 powerlet with a hole drilled through the bottom and a peice of wire threaded from top to bottom(crimp the bottom so it doesnt slide off) and play 'Dont let it stop'