I am presuming that Dave would straighten the barrels if required John? Anyway, the job doesn't take too long to do, and I am sure some of our members will be interested in taking one of these guns off your hands.
Andy
I am presuming that Dave would straighten the barrels if required John? Anyway, the job doesn't take too long to do, and I am sure some of our members will be interested in taking one of these guns off your hands.
Andy
Member, the Feinwerkbau Sport appreciation Society (over 50's chapter)
http://www.rivington-riflemen.eu/ Andy, from the North !
Dave will straighten a barrel if asked.
Often, when a pistol is rebuilt and returned to full power the sighting problems can become more apparent.
I asked Dave to check mine at 10 meters - not something he would normally do (or need to do) - but with Diana or Original break barrels pistols it is worth getting it checked as it could save a return journey (or two !) to get them fixed.
Rossendale Target Shooting Club. Every Tuesday and Thursday evening 7 - 10pm.
I think they were pretty straight tbh Andy, I'm looking forward to shooting them the 6m & 10m I shot of Bob's were very nice
Rossendale Target Shooting Club. Every Tuesday and Thursday evening 7 - 10pm.
That's the plan for these four Bob, one has already gone to a Rivi member I will be using mine for the 6yrd mpl & hopefully the other two will be put into active service within the club
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
I must admit that I like the look of the 10 more than any other family members. Never seen one in the flesh though.
Andy
Member, the Feinwerkbau Sport appreciation Society (over 50's chapter)
http://www.rivington-riflemen.eu/ Andy, from the North !
Don't think you quite grasped the concept of a hammer forged barrel AndyAnyway I'm sure you've done any resale value the world of good with that little tale.
Home Page:
[url]http://www.rivington-riflemen.eu